Home / Import Parts / Flanders BMW Handlebars
 

 

Flanders BMW Handlebars

(c) American Side Road Cycles
SmartCart
(TM) eCommerce System

Click here For 2002 - 2013 Stock Bar Measurements 

Flanders Bars for BMW Bikes - Diameter = 22mm tubing for BMW controls

  • No PayPal for Handlebars: We Cannot accept PayPal payments for Handlebars. Please do not use PayPal to pay for your handlebars.
  • Shipping to you at our Costs: We will add shipping costs to your handlebar order and charge you only at our cost - usually around $17 ground UPS in the United States (orders less than $20.00 will be subject to a $2.00 service charge to offset the handling and billing charges).

 Flanders BMW Handlebars

 Flanders BMW Handlebars

  Flanders BMW Handlebars

   Flanders BMW Low Euro Bar (#12 Euro Bar style 478-35920)

 Flanders BMW Low Sidecar Bar (Magura #12 Euro Sidecar Bar Style 478-35921)

 Flanders BMW R90S Bar (Magura style 478-46300)

 Flanders BMW Handlebars

 
 

 

 
 

 
 

  BMW Sweptback Bar
   BMW 15, 16 Style Bar
   BMW Tall Street, Tour Bar
  BMW Medium Tall Street Bar

Flanders BMW Bars

 
 

 
 
   

 
 
 
   
   

 BMW Medium Tall Street Bar

BMW 17 Style Bar

 BMW K-100 Style Bar

BMW Narrow Sweptback Bar

 BMW R100S Bar

 Flanders BMW Bars
   
   
   

 Flanders Handlebars :

Flanders Company has been producing high quality handcrafted handlebars since 1945. All of the Handlebars featured on the following pages are made of high quality seamless cold drawn steel tubing. They're polished, bent by the mandrel method thereby eliminating unsightly flat outer sections and then chrome plated or black powder coated to perfection.

Handlebar Measurements

All measurements are made in normal riding position.

Height or Rise: Total height measured in a level plane.

Pull Back: Vertical lines from the furthest forward to rear in a level plane.

Center Width: Straight flat section before the start of the bends.

Width: Total overall tip to tip width, no grips or bar end weights.

New cables and new brake lines? When buying new bars, a rough formula to follow is to measure the increased heigth + 1/2 the increased pullback that the new bars will give you. This amount will be very close to how much additional cable and brake line that you may need. However, the best method is to fit the new bars to the motorcycle and then make the increased length determinations, if needed at all.

Additionally, make sure to allow room for your new bars to clear your gas tank on full lock turn.